Brake Caliper Assembly Overview, C38

Brake Caliper Assembly Overview, C38

Rear brakes with automatic adjustment

• Install all parts supplied in the repair kit.





1 - Brake rotor

• Always replace both sides.

• Remove the brake caliper prior to removing.

• Tighten evenly, on both sides, starting from thickness when new.

• Allocation, refer to => [ Rear Brake Specifications ] Rear Brake Specifications.

• Thickness, refer to => [ Rear Brake Specifications ] Rear Brake Specifications.

2 - Ribbed bolt, 75 Nm

• M10 x 1.25 x 60

• Always replace.

• Use socket (T40027)

3 - Brake carrier with guide pins and protective caps

• Replacement carriers are supplied assembled and with sufficient grease on the guide pins.

• If the protective caps or guide pins are damaged, replace them using the repair kit. Use the grease packet supplied to lubricate the guide pins.

4 - Ribbed bolt, 75 Nm

• Always replace.

• M10 x 1.25 x 50.

5 - Brake pads

• Always replace both sides

• Removing and installing, refer to => [ Brake Pads, C38 ] Brake Pads, C38.

• Check pad thickness.

6 - Brake rotor dust shield

7 - Bolt, 10 Nm

• M6 x 12

8 - Self-locking bolt, 35 Nm

• Always replace.

• When loosening and tightening, counter hold on the guide pin.

9 - Brake caliper housing

• Do not disconnect the brake hose when changing brake pads.

• Servicing brake calipers, refer to => [ Brake Caliper Component Overview, C38 ] Brake Caliper Component Overview, C38.

10 - Wheel bolts

• Removing and installing the wheels. Refer to => Steering and Suspension Steering and Suspension

11 - Torx bolt

• Tightening specification: 5 Nm