Backrest Cover
Backrest Cover
• In the illustration, removal and installation of backrest cover is shown on a front seat with the active head restraint system.
• Removing and installing the backrest cover on a front seat without the active head restraint system is the same.
1 Front Seat
2 Retaining Strip
• Always on tunnel side
3 Clips
• Quantity: 3
• replace
4 Backrest Cover
• Removing
- Disengage footwell cover - 8 - on underside of seat at tabs - 7 - (Qty. 4) from spring mat.
- Disengage retaining strip - 2 -.
- Loosen retaining strips - 6 - (Qty. 2) from side panels.
- Press against backrest cover where indicated by arrow - 4 - to remove wire clips - 3 - (Qty. 3).
- Disengage backrest cover - 4 - upward from brackets - 5 - (Qty. 2).
• Installing
To install, perform the steps used in removal in reverse order. When doing so, note the following:
- Replace clips - 3 - (Qty. 3).
- Slide footwell fastening strip into side trim bracket => [ Footwell Cover Retaining Strip, Loosening ].
5 Bracket
• Quantity: 2
6 Fastening Strips
• Quantity: 2
7 Tabs
• Quantity: 4
8 Footwell Cover
Footwell Cover Retaining Strip, Loosening
- Disengage retaining strip - 1 - on footwell cover - 2 - from brackets - 4 - (Qty. 2) on side panel - 3 -.