Sunroof / Moonroof Module: Service and Repair

61 35 714 - Removing and installing/replacing control unit for slide/tilt sunroof





Important!
Read and comply with notes on protection against electrostatic discharge (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).





Necessary preliminary tasks:
- Remove both trim panels Removing and Installing/Replacing Trim Panel For Left or Right Rear Roof Pillar (C-Pillar) for roof pillars at rear
- Remove both rear grab handles 51 16 480 Removing and Installing or Replacing Front Grab Handle





Version with dividing net mounts (1):
Fold back cover (2) for dividing net mount (1).
Release screw (3) and remove dividing net mount (1).

Installation Note:
Observe position indications on reverse side of dividing net mount (1).





Important!
Do not kink roofliner under any circumstances!

Pull off muckets of rear lid and rear doors in roof area.
Unclip roofliner (1) in middle area downwards and lower.

Installation Note:
Holder (2) for roofliner (1) must be replaced.





Note:
Secure drive for slide/tilt sunroof (3) against falling out.

Unlock plug connections (1) and disconnect.

Release screws (2).
Remove control unit for slide/tilt sunroof (3).






Installation Note:
- Initialise slide/tilt sunroof Programming and Relearning.





Replacement:
Carry out programming/coding Programming and Relearning.

Important!
There is a risk of permanent battery discharge if programming/coding is not carried out!