Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay $250), please get in contact with us ASAP: email operation-charm [[at]] tuta.io or click to submit anonymously. (This is the last day we'll be asking)
Starter Motor: Service and Repair
Starter Replacement (V6)
Removal Procedure
1. Turn OFF the ignition.
2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (Battery Negative Cable Disconnection and Connection).
3. Remove the heat shield (2) from the starter.
4. Raise and support the vehicle.Refer to Lifting and Jacking the Vehicle (Service and Repair)
5. Disconnect the knock sensor connector.
6. Remove the battery positive nut (1) and the engine harness connector (2), from the starter solenoid (3).
7. Remove the starter motor bolts (1).
8. Remove the starter motor (2).
Installation Procedure
1. Install the starter motor (2).
Caution: Refer to Fastener Caution (Fastener Caution).
2. Install the starter motor mounting bolts. Tighten to 58 Nm (43 lb ft).
3. Install the battery positive cable and engine harness connector to the starter. Tighten the battery positive cable nut (1) to 25 Nm (18 lb ft).
4. Install the engine harness connector to the starter solenoid.
5. Install the starter heat shield (2) and tighten the bolt (1) to 7 Nm (62 lb in).
6. Connect the knock sensor connector.