Airbag System Verification Test

*AIRBAG SYSTEM VERIFICATION TEST - VER 1

1. *AIRBAG SYSTEM VERIFICATION TEST - VER 1
1. Remove all special tools and jumper wires and reconnect all previously disconnected components - except the Battery.

WARNING: To avoid serious or fatal injury, turn the ignition on, then reconnect the battery.

2. Connect the scan tool to the Data Link Connector - use the most current software available.
3. If sent here from an Occupant Classification System (OCS) related diagnostic procedure or if repairs were made to the OCS, perform the Occupant Classification Module System Verification Test in this Section before proceeding.
4. If repairs were made to the Occupant Classification System (OCS), perform the Belt Tension Sensor Verification Test in this Section before proceeding.
5. With the scan tool, erase stored DTCs in all Airbag System Modules.
6. Turn the ignition off, and wait 15 seconds, then turn the ignition on.
7. Wait one minute, and read active DTCs in all Airbag System Modules.
8. Read the stored DTCs in all Airbag System Modules.
Are any DTCs present or if the original condition still present?

Yes

- Repair is not complete. Select the appropriate diagnostic procedure.

No

- Repair is complete.