Manufacturer Code Charts: 5: 5.3

- Disconnect module harness connector.

- Position vehicle on hoist and raise both front and rear wheels just enough to clear the floor.

- Start the engine (6007) and turn the wheels at 5 mph.

- Place voltmeter on 2000mV AC scale.

- Measure the voltage across module harness connector Pins 3 and 10.

- Is the voltage less than 650mV RMS or is sensor signal erratic?

YES -- Complete pinpoint test for Code 6, steps 6.2 through 6.8. 6
Go to 5.4 to verify. 5.4

NO -- Reinstall module connector. Go to drive test for Code 5. Drive Test 5 Code 5