DT6.7 Make Sure All Steps Are Completed

NOTE: Be sure to complete all steps. Failure to do so could lead to replacing good components.

^ This step requires that a valid diagnostic trouble code has been obtained, all prior diagnostic steps have been completed, and the affected wiring integrity has been verified.

^ Have all prior diagnostic steps been completed as described above?

YES -- Replace anti-lock electronic control module. Go to DT6.8. DT6.8 Clear Code/Pull Code

YES -- If anti-lock electronic control module has been replaced and no resolution has been reached, replace rear axle speed sensor. Go to DT6.8. DT6.8 Clear Code/Pull Code

NO -- Go to diagnostic step last completed and continue.