Test F: The Roof Opening Panel Does Not Open In The Vent Position
PINPOINT TEST F: THE ROOF OPENING PANEL DOES NOT OPEN IN THE VENT POSITIONF1-F3:
F4-F5:
The roof opening sliding glass panel motor/module must be initialized whenever the roof opening sliding glass panel motor/module has been removed from the roof opening panel system, the roof opening panel module assembly has been removed from the vehicle, a new roof opening sliding glass panel motor/module has been installed or a new roof opening panel module assembly has been installed. Refer to Roof Opening Panel Motor Initialization. Programming and Relearning
Normal Operation
The roof opening panel uses an integrated motor and module to operate the roof opening panel sliding glass.
The roof opening sliding glass panel motor/module receives voltage from the accessory delay relay through circuit CBP41 (BU) when the key is in the ACC or RUN position and voltage at all times through circuit SBB18 (YE/RD). Ground is supplied to the roof opening sliding glass panel motor/module through circuit GD133 (BK). The roof opening panel switch receives ground from the roof opening panel motor/module assembly through circuit GD133 (BK). When the roof opening panel tilt switch is pressed, the roof opening panel switch grounds circuit CPR38 (WH/BU) and the roof opening sliding glass panel motor/module opens the roof opening panel sliding glass to the VENT position.
Possible Causes
- Open in circuit CPR38 (WH/BU)
- Roof opening panel switch
- Roof opening sliding glass panel motor/module
- Roof opening sliding glass panel motor not initialized