Test D: DTC B2294 - Restraint System - Curtain Fault
PINPOINT TEST D: DTC B2294 - RESTRAINT SYSTEM - CURTAIN FAULTNormal Operation
The restraints control module (RCM) monitors all safety canopy module circuits for faults. The RCM will set a DTC if an open circuit, short to battery or short to ground fault is detected. The RCM will also set a DTC if the loop resistance is less than 0.9 ohm or greater than 5 ohms. The normal expected resistance range is 1.31 to 4.29 ohms. If a loop resistance is between 0.9 and 1.31 or between 4.29 and 5 ohms, there exists a strong potential for an intermittent fault. If the RCM detects a fault on any of the safety canopy module circuits, it will store DTC B2294 in memory and send a message to the instrument cluster module to illuminate the air bag warning indicator.
Part 1:
Part 2:
This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- Safety canopy module
- RCM
D1:
D1-D4:
D4-D6:
D7-D8:
D9-D11:
D11-D14:
D14-D16:
D16-D18:
D18-D20:
D20-D21:
D22-D23:
D24-D27:
