Pinpoint Test S: The Satellite Radio Is Inoperative/Does Not Operate Correctly - Vehicles With Internal Satellite Radio Receive
Information and Entertainment System
Pinpoint Tests
Pinpoint Test S: The Satellite Radio Is Inoperative/Does Not Operate Correctly - Vehicles With Internal Satellite Radio Receiver
Normal Operation
Digital signals are received by the satellite radio antenna and sent to the Audio Control Module (ACM) through the satellite radio antenna cable. The satellite receiver is internal to the ACM.
If there is an open in the satellite radio antenna circuit, there will be no satellite audio. The audio system display indicates a satellite antenna concern when the audio system is operated in satellite radio mode. To diagnose an open in the satellite radio antenna circuit, Go To Pinpoint Test M. Pinpoint Test M: Poor Reception/Poor Sound Quality/No Sound - Satellite Radio
- DTC U2014:96 (Control Module Hardware: Component Internal Failure) - sets when the navigation ACM detects an internal fault to the built-in satellite radio receiver. This results in complete loss of satellite radio functionality.
This pinpoint test is intended to diagnose the following:
- Subscription status
- ACM
PINPOINT TEST S: THE SATELLITE RADIO IS INOPERATIVE/DOES NOT OPERATE CORRECTLY - VEHICLES WITH INTERNAL SATELLITE RADIO RECEIVER
-------------------------------------------------
S1 CHECK THE ACM DTCs
- Retrieve the ACM DTCs.
- Is DTC U2014:96 present?
Yes
GO to S4.
No
GO to S2.
-------------------------------------------------
S2 CHECK THE SATELLITE RADIO DISPLAY
- Turn the audio system on.
- Operate the audio system in satellite radio mode and observe the Front Display Interface Module (FDIM) display.
- Does satellite radio information show on the FDIM display?
Yes
GO to S3.
No
For vehicles equipped with navigation, Go To Pinpoint Test J. Pinpoint Test J: An Individual Audio Control Module (ACM) Display Touchscreen Display Is Inoperative/Does Not Operate Correctly
For all other vehicles, Go To Pinpoint Test K. Pinpoint Test K: An Individual Front Display Interface Module (FDIM) Display Is Inoperative/Does Not Operate Correctly - Vehicl
-------------------------------------------------
S3 VERIFY AN ACTIVE SUBSCRIPTION
- Operate the audio system in satellite radio mode and observe the FDIM display.
- Does the display indicate the subscription has expired?
Yes
The subscription has expired. INFORM the customer to contact Sirius to re-activate the subscription.
No
If the display indicates a satellite antenna fault, Go To Pinpoint Test M. Pinpoint Test M: Poor Reception/Poor Sound Quality/No Sound - Satellite Radio
Otherwise, GO to S4.
-------------------------------------------------
S4 CHECK FOR CORRECT ACM OPERATION
- Ignition OFF.
- Disconnect all the ACM connectors.
- Check for:
- corrosion
- damaged pins
- pushed-out pins
- Connect all the ACM connectors and make sure they seat correctly.
- Operate the system and determine if the concern is still present.
- Is the concern still present?
Yes
INSTALL a new ACM. REFER to Audio Control Module (ACM) Audio Control Module (ACM). TEST the system for normal operation.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the self-test.
-------------------------------------------------