Removal and Replacement

Engine Support Insulators













Removal and Installation

1. Remove the lower intake manifold. For additional information, refer to Lower Intake Manifold Lower Intake Manifold.

2. Remove the engine support insulator bracket bolt.
- To install, tighten to 90 Nm (66 lb-ft).

3. Install the Engine Support Bar, Universal Adapter Brackets and a suitable piece of chain in the following sequence.

1. Position the 2 Universal Adapter Brackets on top of the cylinder block.

2. Install 2 M8 x 1.25 x 36 mm (1.41 in) bolts and tighten to 10 Nm (89 lb-in).

3. Use a suitable piece of chain.

4. Fasten the chain to the 2 Universal Adapter Brackets with a suitable nut, washer and bolt.





4. Using the Engine Support Bar, lift the engine 12 mm (0.47 in).





5. Remove the nut and ground wire eyelet from the engine support insulator bracket stud.
- To install, tighten to 25 Nm (18 lb-ft).

6. Remove the 3 nuts and the engine support insulator bracket.
- To install, tighten to 55 Nm (41 lb-ft).

7. Remove the 3 bolts and the engine support insulator.
- To install, tighten to 48 Nm (35 lb-ft).

8. To install, reverse the removal procedure.