Antenna - AM/FM

Antenna - AM/FM









Removal and Installation

1. Remove the RH A-pillar lower trim panel.

2. Disconnect the antenna.

1. Disconnect the antenna-to-antenna lead-in cable electrical connector.

2. Release the grommet.





3. Remove the antenna mast.

4. Remove the RH cowl vent grille.

5. Using a suitable tool such as a flat-bladed screwdriver, remove the antenna mast boot.

6. Remove the 3 screws and the antenna.
- Route the cable portion of the antenna through the hole where the grommet was located, and out of the vehicle through the cowl hole.

7. To install, reverse the removal procedure.