Rear Entertainment Module (RETM)

Rear Entertainment Module (RETM)









Removal

NOTE: Module configuration is required when a new Rear Entertainment Module (RETM) is being installed.

1. Upload the RETM configuration to the scan tool.

2. NOTE: Open the display to access the screws.

Remove the 4 screws.

3. Remove the RETM.
- Pull down on the sides of the RETM to disengage the clips from the bracket.

- Using a suitable tool, push the rear most U-hook forward and release the U-hooks.

- Hang the RETM on the J-hooks and disconnect the electrical connector.

- Remove the RETM from the J-hooks.

Installation

1. Hang the RETM on the J-hooks.

2. Connect the electrical connector.

3. Remove the RETM from the J-hooks.

4. NOTE: Tilt the RETM, as necessary, to align it correctly.

Align the left side guide pin with the left side locating hole.

5. Lift up the right side of the RETM and engage the U-hooks.

6. Install the 4 screws.

7. Push on the left and right sides of the RETM to engage the clips.

8. If a new RETM is being installed, download the RETM configuration from the scan tool.