Console - Front, Floor
Console - Front, Floor
Removal and Installation
1. Apply the parking brake.
2. Place the selector lever in the NEUTRAL position.
3. Position the front seats forward.
4. Remove the LH and RH front floor console rear lower bolt covers.
5. Remove the 2 front floor console rear lower bolts.
- To install, tighten to 6 Nm (53 lb-in).
6. Position the front seats rearward.
7. Remove the selector lever trim ring.
8. Lift upward and open the storage compartment lid.
9. Remove the floor console finish panel in the following sequence.
1. Remove the 2 floor console finish panel screws.
2. Lift the floor console finish panel upward to release the retaining clips.
3. If equipped, disconnect the electrical connector.
10. Pull the middle and rear of the LH and RH floor console trim panels outward to release the retaining clips.
11. Pull the front of the LH and RH floor console trim panels downward to detach the trim panel from the pin-type retainers.
12. NOTICE: Damage to the floor console may occur if cardboard is not used to remove the floor console trim panels.
NOTE: LH floor console trim panel shown, RH floor console trim panel similar.
Position a piece of cardboard between the LH and RH floor console trim panels and the floor console.
13. Remove the LH floor console trim panel and cardboard simultaneously.
- If equipped, disconnect the electrical connectors.
14. Remove the RH floor console trim panel and cardboard simultaneously.
- If equipped, disconnect the electrical connectors.
15. Remove the 4 front floor console lower bolts.
- To install, tighten to 6 Nm (53 lb-in).
16. Remove the 2 floor console upper bolts.
17. Disconnect the floor console bulkhead connector.
18. Disconnect the selector lever cable from the selector lever.
19. Remove the selector cable from the selector lever cable bracket.
20. Remove the floor console.
- Pull the floor console rearward.
21. To install, reverse the removal procedure.
- Make sure to align the retaining clips to the adjacent retaining clip holes.