Seat Wire Harness Routing

Seat Wire Harness Routing

1. For correct front passenger seat cushion wire harness routing, refer to the following views.
- For power passenger seat track, match the numbers in the wire harness view to the numbers in the retainer and connector location views and attach accordingly.

- For manual passenger seat track, match the view to the seat track and wire harness being assembled and attach accordingly.

- Wire harness retainers and electrical connectors are called out in assembly order.

2. NOTE: Illustration shows Occupant Classification Sensor (OCS) weight sensor bolts in their installed position with the seat in the vehicle (arrow indicates front).

Verify the correct passenger seat OCS weight sensor bolt electrical connector positions using the illustration.

- For correct identification and placement of the 4 OCS weight sensor bolt electrical connectors, use the wire colors identified in the Wiring Diagram Set 46. Connecting the incorrect connector to a sensor will cause DTCs to set and will result in an unsuccessful OCS System Reset. Diagrams By Number






Power Passenger Seat Track

Wire Harness View

NOTE: Illustrations show wire harness with heat. If not equipped with heat option, skip heated seat numerical option content.






Wire Harness Retainer and Connector Location View

NOTE: See supporting views for missing numbers.










a Make sure the wire harness passes on the correct side, as shown.

Retainer and Connector Location View, Outboard Side From Underneath





Retainer and Connector Location View, Front Inboard





Retainer and Connector Location View, Outboard Side





Retainer and Connector Location View, Backrest





Retainer and Connector Location View, Seat Control Switch





Wire Harness Installed View





1. Make sure the passenger seat cushion wire harness is correctly routed and attached.


Manual Passenger Seat Track

Retainer and Connector Location View, Cushion Frame From Underneath

NOTE: See supporting views for missing numbers.










a Make sure the wire harness passes on the correct side of seat track lever, as shown.

Retainer and Connector Location View, Outboard Side of Seat





Retainer and Connector Location View, Front of Seat Track





1. Make sure the passenger seat cushion wire harness is correctly routed and attached.