Instrument Cluster (IC)

Instrument Cluster (IC)









Removal

1. If installing a new Instrument Cluster (IC), upload the module configuration information to the scan tool.

2. Remove the IC finish panel.

3. Lower the steering column to the lowest position.

4. Remove the 4 screws and the IC.
- Disconnect the electrical connector.

Installation

1. Position the IC in the instrument panel, connect the electrical connector and install the 4 screws.

2. Install the IC finish panel.

3. If installing a new IC, download the IC configuration information from the scan tool into the new IC.

4. NOTE: If a new IC is installed, the IC and the PCM require a parameter reset to allow the IC and the PCM to recognize each other. Failure to carry out the parameter reset to the IC and the PCM results in a no start condition.

If installing a new IC, carry out the parameter reset procedure. Passive Anti-Theft System (PATS)

5. NOTE: The vehicles Passive Anti-Theft System (PATS) keys must be programmed to the new IC.

If installing a new IC, carry out the PATS key programming. Programming and Relearning