Pinpoint Test J: An Individual Demand Lamp Is Inoperative

Interior Lighting

Pinpoint Tests

Pinpoint Test J: An Individual Demand Lamp Is Inoperative

Refer to Wiring Diagram Set 89, Interior Lamps for schematic and connector information. Diagrams By Number

Normal Operation

The Smart Junction Box (SJB) supplies voltage to the demand lamps on circuit CLN09 (YE/GN). The demand lamps are grounded through circuit GD133 (BK).

This pinpoint test is intended to diagnose the following:

- Wiring, terminals or connectors
- Interior lamp



PINPOINT TEST J: AN INDIVIDUAL DEMAND LAMP IS INOPERATIVE

NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.

-------------------------------------------------
J1 CHECK CIRCUIT CLN09 (YE/GN) FOR AN OPEN


- Ignition OFF.
- Disconnect: Suspect Demand Lamp .
- Ignition ON.
- Measure the voltage between the suspect demand lamp, harness side and ground as follows:





- Is the voltage greater than 10 volts?

Yes
GO to J2.

No
REPAIR the circuit. TEST the system for normal operation.

-------------------------------------------------
J2 CHECK THE GROUND CIRCUIT FOR AN OPEN


- Measure the resistance between the suspect demand lamp, harness side and ground as follows:





- Is the resistance less than 5 ohms?

Yes
For the LH or RH second row lamps, INSTALL a new interior lamp for the lamp in question. TEST the system for normal operation.

For all other interior lamps, INSTALL a new interior lamp for the lamp in question. REFER to Interior Lamp Service and Repair. TEST the system for normal operation.

No
REPAIR circuit GD133 (BK) for an open. TEST the system for normal operation.

-------------------------------------------------