Console - Floor

Console - Floor

Edge Floor Console









MKX Floor Console









All vehicles

1. Position the selector lever to NEUTRAL.

2. NOTE: The seats must be in the full raised position to access the bolts.

Position the seats forward and remove the 2 floor console rear bolts.

- To install, tighten to 6 Nm (53 lb-in).

3. Remove the 2 floor console side panels.

4. NOTE: The seats must be in the full raised position to access the bolts.

Position the seats rearward and remove the 2 floor console side panels and 2 floor console center bolts.

- To install, tighten to 6 Nm (53 lb-in).

5. Remove the floor console finish panel.

MKX only

6. Remove the storage bin.
- Remove the 2 scrivets.

- Disconnect the power point electrical connector.

7. Remove the 2 floor console front side bolts.
- To install, tighten to 6 Nm (53 lb-in).

All vehicles

8. Remove the 2 floor console-to-instrument panel bolts.
- To install, tighten to 6 Nm (53 lb-in).

9. Disconnect the floor console electrical connector from the lower right front wiring harness.

10. Remove the floor console.

11. To install, reverse the removal procedure.