Selector Lever Knob

Selector Lever Knob









Removal

MKX only

1. Using a suitable tool, remove the selector lever trim ring.





All vehicles

2. Lift the armrest. Using a suitable tool, remove the center console trim cover.





3. NOTE: Center console side trim cover removed for clarity.

Disconnect the Transmission Control Switch (TCS) electrical connector.





4. Remove and discard the selector lever knob trim covers by carefully prying out on the bottom front corners, and then pry out on the top front corner and remove the covers.





5. NOTE: Inspect the knob body for damage. Install a new knob body if necessary.

Remove and discard the 2 selector lever knob screws. Remove the selector lever knob while routing the TCS electrical connector harness out of the selector lever.





Installation

All vehicles

1. Route the TCS electrical connector harness through the selector lever and install the shift knob and 2 new screws. Loosely install both screws before tightening.
- Tighten to 2 Nm (18 lb-in).





2. NOTE: Be sure that the selector lever knob bezel is correctly installed on the selector lever knob.

Install new selector lever knob trim covers.





Edge only

3. Route the TCS electrical connector wires behind the selector lever bezel light bulb wires.

1. TCS electrical connector wires

2. Selector lever light bulb wires





All vehicles

4. NOTE: Center console side trim cover removed for clarity.

Connect the TCS electrical connector.





5. Install the center console trim cover.





MKX only

6. Install the selector lever trim ring.