Front Bumper Cover / Fascia: Service and Repair

Bumper Cover - Front

Removal and Installation

1. Remove the 3 lower air deflector pin-type retainers.
- Position the air deflector aside.





2. Remove the 2 front bumper cover lower pin-type retainers.





3. Remove the 4 LH and RH front fender splash shield screws.

4. Remove the 4 LH and RH front bumper cover-to-fender bolts.
- To install, tighten to 11 Nm (97 lb-in).

5. If equipped, disconnect the fog lamp electrical connector.

6. If equipped, disconnect the park aid sensor electrical connector.

7. Remove the upper air deflector.
- Remove the 10 pin-type retainers.





NOTE: Right side shown, left side similar.

8. Remove the 2 upper pin-type retainers for the lower air deflector.





9. Remove the 4 grille-to-radiator support bolts.

10. Remove the front bumper cover.

11. To install, reverse the removal procedure.