Pinpoint Test J: PCA Solenoid

Pinpoint Tests - OSC Equipped Vehicle

Pinpoint Tests, Diesel Engine Vehicles

PINPOINT TEST J: PCA SOLENOID

NOTE: This test should only be used if DTC P0748, P0960, P0962 or P0963 is present.

NOTE: Read and record all DTCs.

NOTE: Refer to the Transmission Vehicle Harness Connector illustration within the Transmission Connector Layouts Transmission Connector Layouts procedure.

NOTE: Refer to the Internal Harness Connector illustration within the Transmission Connector Layouts Transmission Connector Layouts procedure.

-------------------------------------------------
J1 CHECK TRANSMISSION VEHICLE HARNESS FOR CONTINUITY


- Ignition OFF.
- Disconnect: Transmission Control Module (TCM) C1750.
- Disconnect: Transmission Vehicle Harness C1385.
- Check to make sure the transmission vehicle harness C1385 is fully seated, terminals are fully engaged in the connector and are in good condition before proceeding.
- Measure the resistance between TCM C1750 and C1385 using the following chart.









- Is resistance less than 5 ohms?

Yes
GO to J2.

No
REPAIR the open circuit. CLEAR the DTCs. TEST the system for normal operation.

-------------------------------------------------
J2 CHECK TRANSMISSION VEHICLE HARNESS FOR SHORT TO GROUND


- Measure the resistance between TCM C1750, harness side and ground using the following chart.









- Is resistance greater than 10,000 ohms?

Yes
GO to J3.

No
REPAIR short circuit. CLEAR the DTCs. TEST the system for normal operation.

-------------------------------------------------
J3 CHECK THE TRANSMISSION INTERNAL HARNESS FOR AN OPEN


- Drain the transmission fluid.
- Remove the transmission fluid pan.
- Disconnect: Pressure Control Solenoid A (PCA).
- Measure the resistance between transmission internal harness C1385 and the PCA solenoid using the following chart.









- Is resistance less than 5 ohms?

Yes
GO to J4.

No
INSTALL a new transmission harness. CLEAR the DTCs. TEST the system for normal operation.

-------------------------------------------------
J4 CHECK THE TRANSMISSION INTERNAL HARNESS FOR A SHORT TO GROUND


- Measure the resistance between transmission internal harness C1385 and ground using the following chart.









- Is resistance greater than 10,000 ohms?

Yes
GO to J5.

No
INSTALL a new transmission harness. CLEAR the DTCs. TEST the system for normal operation.

-------------------------------------------------
J5 CHECK THE PCA RESISTANCE


- Measure the resistance between terminals 1 and 2 at the PCA.




- Is resistance between 4.88-5.48 ohms?

Yes
INSTALL a new TCM.

No
INSTALL a new PCA. CLEAR the DTCs. TEST the system for normal operation.

-------------------------------------------------