Valve Body: Service and Repair

Solenoid Body Assembly









Removal

1. Remove the transmission fluid pan, gasket and filter. For additional information, refer to Fluid Pan, Gasket and Filter Fluid Pan, Gasket and Filter.

2. Disconnect the transmission vehicle harness connector.





3. NOTE: While lowering the solenoid body, the manual valve may fall out of the solenoid body.

Remove the solenoid body.

1. Disconnect the Transmission Range (TR) sensor connector.

2. Remove the solenoid body bolts.

3. Remove the solenoid body.





4. Remove the solenoid body gasket.





Installation

1. Install a new solenoid body gasket.





2. Using the Valve Body Aligner, install the solenoid body and loosely install the bolts.
- While installing the solenoid body, align the manual valve.





3. Tighten all the bolts in the sequence shown.
- Tighten to 13 Nm (115 lb-in).





4. Connect the TR sensor connector.





5. Install the transmission fluid filter, pan gasket and pan. For additional information, refer to Fluid Pan, Gasket and Filter Fluid Pan, Gasket and Filter.

6. Connect the transmission vehicle harness connector.
- Tighten to 5 Nm (44 lb-in).