Alternator: Service and Repair

Generator - 4.0L SOHC









Removal and Installation

1. Disconnect the battery. For additional information, refer to Battery.

2. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.

3. Rotate the Front End Accessory Drive (FEAD) belt tensioner counterclockwise and position the accessory drive belt aside.

4. Disconnect the 2 electrical connectors from the generator.

5. Position the protective cover aside, remove the nut and position the generator B+ terminal aside.
- To install, tighten to 17 Nm (150 lb-in).

6. Remove the 2 bolts from the generator.
- To install, tighten to 47 Nm (35 lb-ft).

7. Remove the stud bolt, position the generator harness bracket aside and remove the generator.
- To install, tighten to 47 Nm (35 lb-ft).

8. To install, reverse the removal procedure.