Roof Opening Panel Motor

Roof Opening Panel Motor

Removal and Installation

NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel system, including: whenever the roof opening panel motor has been removed from the roof panel system, the roof opening panel glass has been removed from the roof opening panel system, the roof opening panel assembly has been removed from the vehicle, a new roof opening panel motor has been installed, a new roof opening panel glass has been installed or a new roof opening panel assembly has been installed. For additional information, refer to Roof Opening Panel Motor Initialization Programming and Relearning.

1. Remove the headliner. For additional information, refer to Interior Trim and Ornamentation Service and Repair.

2. Disconnect the roof opening panel motor electrical connector.

3. Remove the 3 roof opening panel motor screws and the roof opening panel motor.
- To install, tighten to 8 Nm (71 lb-in).





4. To install, reverse the removal procedure.
- Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization Programming and Relearning.