Satellite Digital Audio Receiver System (SDARS) Module

Satellite Digital Audio Receiver System (SDARS) Module









Removal and Installation

NOTE: This procedure applies to vehicles without navigation only. For vehicles with navigation, the Satellite Digital Audio Receiver System (SDARS) module is integral to the Audio Control Module (ACM).

1. NOTE: Module configuration is required when a new SDARS module is being installed.

Upload the SDARS module configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Module Configuration Programmable Module Installation (PMI).

2. Remove the center console. For additional information, refer to Instrument Panel and Console Console - Front, Floor Console - Front, Floor.

3. Remove the 4 screws and the SDARS module.
- Disconnect the electrical connectors.

- To install, tighten the screws to 8 Nm (71 lb-in).

4. To install, reverse the removal procedure.
- Download the configuration information to the SDARS module. For additional information, refer to PMI in Module Configuration Programmable Module Installation (PMI).