Power Running Board (PRB) Bracket

Power Running Board (PRB) Bracket

Regular Wagon

NOTE: LH shown, RH similar.











Extended Wagon

NOTE: LH shown, RH similar.











Removal and Installation

All brackets

1. Remove the Power Running Board (PRB) step. For additional information, refer to Power Running Board (PRB) Step Power Running Board (PRB) Step.

Front bracket - regular wagon

2. NOTE: The PRB motor is part of the front bracket assembly.

Disconnect the PRB motor electrical connector.





3. NOTE: Only 3 bolts shown.

Remove the PRB front bracket 2 upper and 2 lower bolts and the front bracket assembly.

- To install, tighten to 23 Nm (17 lb-ft).





Rear bracket - regular wagon

4. Remove the PRB rear bracket 2 upper and 2 lower bolts and the rear bracket assembly.
- To install, tighten to 23 Nm (17 lb-ft).





Extended wagon

5. NOTICE: An assistant is required to hold the Power Running Board (PRB) bracket assembly prior to removing the bolts. Failure to follow this instruction may result in damage to the component.

Remove the 4 front and rear bracket upper and lower bolts.

- To install, tighten to 23 Nm (17 lb-ft).

All brackets

6. To install, reverse the removal procedure.