Trunk / Liftgate Shock / Support: Service and Repair

Power Liftgate Rod





Removal and Installation









1. Remove the LH quarter trim panel. For additional information, refer to Interior Trim and Ornamentation Quarter Trim Panel.

2. Unclip the power liftgate rod from the motor assembly.
- Squeeze the clip as shown to release and position upward on the rod assembly.





3. Remove the cover and the power liftgate rod-to-liftgate retaining nut.
- To install, apply threadlock to the threads of fastener and tighten to 11 Nm (97 lb-in).





4. Remove the power liftgate rod-to-bracket bolt and the power liftgate rod assembly.
- To install, tighten to 30 Nm (22 lb-ft).

5. To install, reverse the removal procedure.
- Initialize the power liftgate. For additional information, refer to Power Liftgate Initialization Procedures.