Roof Opening Panel Motor

Roof Opening Panel Motor

Removal

NOTE: The roof opening panel must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof opening panel has been removed from the roof opening panel assembly, a new roof opening panel motor/module has been installed or when a new roof opening panel assembly has been installed. For additional information, refer to Roof Opening Panel Motor Initialization Programming and Relearning.

1. Remove the headliner. For additional information, refer to Interior Trim and Ornamentation Service and Repair.

2. Disconnect the roof opening panel motor electrical connector.





3. Remove the roof opening panel motor.
- Remove the 3 screws.





Installation

1. Connect the roof opening panel motor electrical connector.





2. NOTE: When installing the roof opening panel motor/module, align the 3 attach holes before engaging the drive gear into the roof opening panel drive cable. Do not rotate the motor assembly after the drive gear is engaged with the roof opening panel drive cable. Otherwise, the cable can bind.

Install the roof opening panel motor.

- Align the attach holes, then install the 3 screws and tighten to 4 Nm (35 lb-in).





3. Connect the overhead console electrical connectors.

4. Initialize the roof opening panel motor/module. For additional information, refer to Roof Opening Panel Motor Initialization Programming and Relearning.

5. Disconnect the overhead console electrical connectors.

6. Install the headliner. For additional information, refer to Interior Trim and Ornamentation Service and Repair.