Power-Fold Seat Motor

Power-Fold Seat Motor

Removal and Installation

NOTE: For parts identification and locations, refer to Seat - Exploded View, Third Row Seat - Exploded View, Third Row.

1. Remove the load floor panel.

2. Remove the 2 bolts and mid-floor panel support.
- Release the 3 pin-type retainers.

3. Disconnect the power seat motor electrical connector and detach the wiring harness.

4. Remove the bracket-to-pivot bolt and bushing from the power-fold seat motor.
- Note bushing shoulder position for correct installation.

- To install, tighten to 30 Nm (22 lb-ft).

5. Remove the bracket-to-latch bolt and power-fold seat motor.
- Slide the power-fold seat motor and bracket away from the latch and torque shaft.
- For installation, slightly rotate the torque shaft until seated into the power-fold seat motor.

- To install, tighten to 30 Nm (22 lb-ft).

6. To install, reverse the removal procedure.