Accelerator Pedal - Adjustable

Accelerator Pedal - Adjustable









Removal and Installation

NOTE: The brake pedal and the accelerator pedal must be in the same position when installing a new cable or a new pedal. The pedals must be in the all the way forward position.

1. NOTE: To prevent setting DTCs, make sure the ignition switch is in the OFF position prior to disconnecting the accelerator pedal electrical connector.

Disconnect the Accelerator Pedal Position (APP) sensor electrical connector.

2. Disconnect the accelerator pedal-to-brake pedal cable from the brake pedal.

3. Remove the 3 bolts and the accelerator pedal assembly.
- To install, tighten to 25 Nm (18 lb-ft).

4. To install, reverse the removal procedure.