Crankshaft Pulley

Crankshaft Pulley

Special Tool(s)






Material(s)






Removal

1. With the vehicle in NEUTRAL, position it on a hoist. REFER to Lifting Points Service and Repair.

2. Remove the RH (Right Hand) splash shield. REFER to Fender Splash Shield Fender Splash Shield.

3. Remove the accessory drive belt. REFER to Accessory Drive.

4. Using 303-D055 (D85L-6000-A) , remove the crankshaft pulley bolt and washer.

1. Discard the bolt.





5. Using 303-D121, remove the crankshaft pulley.





Installation

1. Lubricate the crankshaft front seal inner lip with clean engine oil.

2. NOTE: Lubricate the outside diameter sealing surfaces with clean engine oil.

Using 303-102 (T74P-6316-B) and 303-335 (T88T-6701-A) , install the crankshaft pulley.





3. Using 303-D055 (D85L-6000-A) , install the crankshaft pulley washer and new bolt and tighten in 4 stages.

- Stage 1: Tighten to 120 Nm (89 lb-ft).

- Stage 2: Loosen one full turn.

- Stage 3: Tighten to 50 Nm (37 lb-ft).

- Stage 4: Tighten an additional 90 degrees.





4. Install the accessory drive belt. REFER to Accessory Drive.

5. Install the RH (Right Hand) splash shield. REFER to Fender Splash Shield Fender Splash Shield.