Power Steering Pump to Steering Gear Pressure Line

Power Steering Pump to Steering Gear Pressure Line













Removal and Installation

NOTICE: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power steering components may result.

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Detach the wiring harness retainer from the pressure line.

3. Remove the pressure line clamp plate-to-pump bolt and disconnect the pressure line from the pump.
- To install, tighten to 25 Nm (18 lb-ft).

4. Remove the pressure line bracket-to-crossmember bolt.
- To install, tighten to 7 Nm (62 lb-in).

5. Remove the steering line clamp plate-to-steering gear bolt, disconnect the lines from the steering gear and remove the pressure line.
- To install, tighten the steering line clamp plate-to-steering gear bolt to 23 Nm (17 lb-ft).

6. To install, reverse the removal procedure.

7. Fill the power steering system. For additional information, refer to Steering System - Hydraulic Power Assist Steering (HPAS) Power Steering System Filling.