Transfer Case Shift Lever

Transfer Case Shift Lever













Removal

NOTE: The transfer case shift lever and cable are serviced as an assembly.

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Release the clip securing the shift cable to the shift cable mounting bracket and disconnect the cable end from the transfer case shift lever.

3. NOTICE: Install a durable cloth between the Transmission Fluid Pump Remover and the shift lever shaft and knob, failure to do so may cause damage to the components.

Remove the shift lever knob, using the Transmission Fluid Pump Remover and the Slide Hammer.





4. Remove the consolette by pulling upward, releasing the 4 clip-type retainers securing the consolette.

5. Remove the LH cowl trim panel. For additional information, refer to Interior Trim and Ornamentation Cowl Side Trim Panel.

6. Position the carpet away from the shift lever.

7. Remove the 4 bolts and the shift lever assembly.

Installation

1. Install the shift lever assembly and the 4 bolts.
- Tighten to 7 Nm (62 lb-in).

2. Position the carpet in place.

3. Install the LH cowl trim panel. For additional information, refer to Interior Trim and Ornamentation Cowl Side Trim Panel.

4. Install the consolette, securing the 4 clip-type retainers.

5. Install the shift lever knob, carefully tap the knob until it is fully seated.

6. Secure the shift cable to the shift cable mounting bracket and connect the cable end to the transfer case shift lever.