Exterior Mirror

Exterior Mirror

Removal and Installation

NOTE: Do not remove the exterior mirror assembly when repairing an individual part. Individual components can be installed without removing the exterior mirror.

NOTE: The power folding mirrors may need to be synchronized anytime the mirrors are folded or unfolded without using the exterior mirror control switch, or if a new power folding mirror is installed. For additional information, refer to Exterior Mirror Motor Synchronization - Power Folding Programming and Relearning.

1. Remove the front door trim panel. For additional information, refer to Interior Trim and Ornamentation Service and Repair.

2. Position aside the water shield to gain access to the electrical connector.
- Disconnect the electrical connector, if equipped.

3. Remove the 3 exterior mirror nuts.
- To install, tighten to 12 Nm (106 lb-in).

4. Remove the exterior mirror.

5. To install, reverse the removal procedure.
- If equipped with power folding mirrors, they must be synchronized. For additional information, refer to Exterior Mirror Motor Synchronization - Power Folding Programming and Relearning.