Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2011 >> F 350 2WD Super Duty V8-6.7L DSL Turbo >> Repair and Diagnosis >> Body and Frame >> Seats >> Testing and Inspection >> Pinpoint Tests >> Pinpoint Test R: DTC B111C

Pinpoint Test R: DTC B111C




Seats

Pinpoint Tests

Pinpoint Test R: DTC B111C

Refer to Wiring Diagram Set 119, Climate Controlled Seats for schematic and connector information. Diagrams By Number

Normal Operation

The seat cushion and backrest are equipped with a Thermo-Electric Device (TED) assembly that includes a seat blower (fan motor, serviced as an assembly with the TED). If the Dual Climate Controlled Seat Module (DCSM) detects an open circuit or high TED resistance, the following DTC will be set:

- DTC B111C (Passenger Thermoelectric Driver Open Load) - If DCSM outputs to the passenger seat backrest or cushion TED (circuit pin A, B, C or D at the DCSM connector) or any components within these circuit loops are open, disconnected or a TED resistance greater than 90,000 ohms is sensed, the DCSM continues normal operation and sets this DTC.

This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- TED assembly
- DCSM

PINPOINT TEST R: DTC B111C

NOTICE: Use the correct probe adapter(s) from the Flex Probe Kit when taking measurements. Failure to use the correct probe adapter(s) may damage the connector.

-------------------------------------------------
R1 CHECK THE PASSENGER TED CIRCUITS FOR AN OPEN

NOTE: If a seat equipped with a seat mounted side air bag is being serviced, the Supplemental Restraint System (SRS) must be depowered. Refer to Supplemental Restraint System Supplemental Restraint System (SRS) Depowering and Repowering.

NOTE: The air bag warning lamp illuminates when the Restraints Control Module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate an SRS fault.

NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

- Ignition OFF.

- WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any air bag module when the battery is connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.

- For vehicles equipped with seat side air bags, carry out the following:
- Depower the SRS. Refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of Supplemental Restraint System Supplemental Restraint System (SRS) Depowering and Repowering.
- Disconnect the passenger seat side air bag module C339.
- Connect the battery ground cable. Refer to Battery, Mounting and Cables Battery Disconnect / Connect.
- Disconnect: DCSM C3265A.
- Disconnect: Passenger Cushion TED C3040.
- Disconnect: Passenger Backrest TED C3039.
- Measure the resistance between DCSM C3265A, harness side and passenger cushion TED C3040, harness side; and between DCSM C3265A, harness side and passenger backrest TED C3039, harness side using the following chart:








- Are the resistances less than 5 ohms?

Yes
GO to R2.

No
REPAIR the circuit(s). CLEAR the DTCs. REPEAT the self-test.

For vehicles equipped with seat side air bags, DISCONNECT the battery ground cable. CONNECT passenger seat side air bag module C339. REPOWER the SRS. REFER to Supplemental Restraint System Supplemental Restraint System (SRS) Depowering and Repowering.

-------------------------------------------------
R2 CHECK THE PASSENGER TED CIRCUITS FOR A SHORT TO VOLTAGE

- Ignition ON.
- Measure the voltage between DCSM C3265A, harness side and ground using the following chart:








- Is any voltage present on any circuits?

Yes
REPAIR the circuit(s). CLEAR the DTCs. REPEAT the self-test.

For vehicles equipped with seat side air bags, DISCONNECT the battery ground cable. CONNECT passenger seat side air bag module C339. REPOWER the SRS. REFER to Supplemental Restraint System Supplemental Restraint System (SRS) Depowering and Repowering.

No
GO to R3.

-------------------------------------------------
R3 CHECK THE PASSENGER BACKREST TED AND CUSHION TED RESISTANCES

- Ignition OFF.
- Measure the resistance between:
- passenger backrest TED C3039 pins 1 and 3, component side.
- passenger cushion TED C3040 pins 1 and 3, component side.




- Are the resistances between 0.9 and 10 ohms?

Yes
GO to R4.

No
If the passenger backrest TED resistance is not between 0.9 and 10 ohms, INSTALL a new passenger backrest TED. REFER to Seat Backrest - Front, Bucket Seat Bucket Seat. CLEAR the DTCs. REPEAT the self-test.

For vehicles equipped with seat side air bags, DISCONNECT the battery ground cable. CONNECT passenger seat side air bag module C339. REPOWER the SRS. REFER to Supplemental Restraint System Supplemental Restraint System (SRS) Depowering and Repowering. If the passenger cushion TED resistance is not between 0.9 and 10 ohms, INSTALL a new passenger cushion TED. REFER to Seat Cushion - Front, Bucket Seat Bucket Seat. CLEAR the DTCs. REPEAT the self-test.

For vehicles equipped with seat side air bags, DISCONNECT the battery ground cable. CONNECT passenger seat side air bag module C339. REPOWER the SRS. REFER to Supplemental Restraint System Supplemental Restraint System (SRS) Depowering and Repowering.

-------------------------------------------------
R4 CHECK FOR CORRECT DCSM OPERATION

- Disconnect all the DCSM electrical connectors.
- Check the harness and component side connectors for the following:

- corrosion.
- damaged pins.
- pushed-out pins.
- Connect all the DCSM electrical connectors and make sure they seat correctly.
- Start the engine.
- Operate the climate controlled seats and verify system operation.
- CLEAR all CMDTCs.
- Enter the following diagnostic mode on the scan tool: Self Test - DCSM.
- Is DTC B111C still present?

Yes
INSTALL a new DCSM. REFER to Dual Climate Controlled Seat Module (DCSM) Service and Repair. CLEAR all CMDTCs. REPEAT the self-test.

For vehicles equipped with seat side air bags, DISCONNECT the battery ground cable. CONNECT passenger seat side air bag module C339. REPOWER the SRS. REFER to Supplemental Restraint System Supplemental Restraint System (SRS) Depowering and Repowering.

No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR all CMDTCs. REPEAT the self-test.

For vehicles equipped with seat side air bags, DISCONNECT the battery ground cable. CONNECT passenger seat side air bag module C339. REPOWER the SRS. REFER to Supplemental Restraint System Supplemental Restraint System (SRS) Depowering and Repowering.

-------------------------------------------------
pro multis · About Operation CHARM