Ignition Coil-On-Plug

Ignition Coil-On-Plug





Removal and Installation

1. Disconnect the 10 ignition coil-on-plug electrical connectors.

2. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.

Remove the bolts and the 10 ignition coil-on-plugs.

- To install, tighten to 6 Nm (53 lb-in).

3. NOTE: Verify that the ignition coil-on-plug spring is correctly located inside the ignition coil-on-plug boot and that there is no damage to the tip of the boot.

To install, reverse the removal procedure.

- Apply a light coat of dielectric compound to the inside of the ignition coil-on-plug boots.