Console - Floor

Console - Floor

Floor Console Finish Panels









Floor Console and Fasteners









Removal and Installation

1. Remove the 2 lower rear console bolts.
- Position the passengers side inboard seat track cover aside to access the bolt.

- To install, tighten to 70 Nm (52 lb-ft).

2. Remove the bolt covers and the lower 2 center console bolts.
- To install, tighten to 4 Nm (35 lb-In).

3. Remove the bolt covers and the lower 2 front console bolts.
- To install, tighten to 4 Nm (35 lb-In).

4. Open the console lid and remove the storage trays.

5. Using a suitable tool, pry up from the rear and remove the console finish panel.

6. Remove the 2 upper console bolts.
- To install, tighten to 3 Nm (27 lb-In).

7. Disconnect the electrical connector from the right side of the floor console and remove the floor console.

8. To install, reverse the removal procedure.