Operation CHARM: Car repair manuals for everyone.

Pinpoint Test D: All The Interior Courtesy Lamps Are Inoperative




Interior Lighting

Pinpoint Tests

Pinpoint Test D: All The Interior Courtesy Lamps Are Inoperative

Refer to Wiring Diagram Set 89, Interior Lamps for schematic and connector information. Diagrams By Number

Normal Operation

Power is supplied to the courtesy lamps through the Smart Junction Box (SJB) fuse 9 (15A). When any door or the liftgate is opened, the ajar switch opens, signaling the SJB. The SJB monitors the ajar switches, instrument panel dimmer switch and Integrated Keyhead Transmitter (IKT) input. Based on the input status, the SJB supplies voltage to the courtesy lamps.

- DTC B2A35 (Interior Lighting Output Circuit Open) - an on-demand DTC that sets when the SJB detects an open from the interior lighting output circuit.
- DTC B2A36 (Interior Lighting Output Circuit Short To Ground) - a continuous and on-demand DTC that sets when the SJB detects a short to ground from the interior lighting output circuit.

This pinpoint test is intended to diagnose the following:

- Fuse
- Wiring, terminals or connectors
- SJB


PINPOINT TEST D: ALL THE INTERIOR COURTESY LAMPS ARE INOPERATIVE

NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.

-------------------------------------------------
D1 CHECK THE OPERATION OF THE DEMAND LIGHTING


- Operate the demand lighting function on any courtesy lamp.
- Does the courtesy lamp illuminate with the demand lighting function?

Yes
GO to D2.

No
REPAIR circuit GD133 (BK) for an open. TEST the system for normal operation.

-------------------------------------------------
D2 BYPASS THE SJB


- Ignition OFF.
- Disconnect: SJB C2280a.

- NOTE: If the jumper wire fails, refer to the Wiring Diagrams to identify the possible causes of the circuit short. Diagrams By Number After the repair:

If no DTCs are present, test the system for normal operation.

If DTC B106E is present, clear the DTCs and repeat the self-test (required to enable the courtesy lamp output driver if DTC B106E is present). Test the system for normal operation.

If DTC B106F is present, install a new SJB. Refer to Multifunction Electronic Modules Service and Repair. Test the system for normal operation.

- Connect a fused jumper wire between the SJB C2280a-9, circuit VLN33 (GY/VT), harness side and battery positive.




- Do the courtesy lamps illuminate?

Yes
VERIFY the SJB fuse 9 (15A) is OK. If OK, GO to D3. If not OK, REFER to the Wiring Diagrams to identify the possible causes of the circuit short. Diagrams By Number

No
REPAIR circuit VLN33 (GY/VT) for an open. TEST the system for normal operation.

-------------------------------------------------
D3 CHECK FOR CORRECT SJB OPERATION


- Disconnect all the SJB connectors.
- Check for:
- corrosion
- damaged pins
- pushed-out pins

- Connect all the SJB connectors and make sure they seat correctly.
- Operate the system and verify the concern is still present.
- Is the concern still present?

Yes
INSTALL a new SJB. REFER to Multifunction Electronic Modules Service and Repair. TEST the system for normal operation.

No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.

-------------------------------------------------