C-Pillar Trim Panel - SuperCab Two-Door

C-Pillar Trim Panel - SuperCab Two-Door





All vehicles

1. Remove the door scuff plate trim panel.

2. Remove the A-pillar trim panel. For additional information, refer to A-Pillar Trim Panel A-Pillar Trim Panel.

3. Remove the cab rear trim panel.

4. NOTE: If the safety belt guide cover is damaged or if it does not remain closed, install a new cover.

Remove the front belt guide cover.

- Release the retaining tabs and remove the cover.





5. Remove the bolt and safety belt guide.
- Use the Safety Belt Bolt Bit to remove the bolt.
- To install, tighten to 40 Nm (30 lb-ft).

- Remove the safety belt guide.





6. Remove the safety belt anchor bolt.
- Use the Safety Belt Bolt Bit to remove the bolt.
- To install, tighten to 40 Nm (30 lb-ft).





Without center-facing rear seat

7. Remove the C-pillar trim panel floor screws.





8. Open the storage compartment.





With center-facing rear seat

9. Remove the pin-type retainers and lower rear trim panel.





10. Remove the C-pillar trim panel floor screws.





11. Open the rear seat.





All vehicles

12. Remove the C-pillar trim panel pin-type retainers.





13. Disconnect the radio speaker electrical connector.

14. Remove the C-pillar trim panel.
- Feed the safety belt webbing through the quarter trim panel.

15. To install, reverse the removal procedure.