Procedures

Parking Brake Cable Tension Release

1. Remove the LH cowl panel. For additional information, refer to Interior Trim - Exploded View in Interior Trim and Ornamentation Interior Trim - Exploded View.

2. With the help of an assistant, release the parking brake cable tension by pulling down on the intermediate cable at the cable-to-cable connector clip until the parking brake control sector rotates to its stop and a 4 mm (0.15 in) x 150 mm (5.9 in) retainer pin can be inserted.





3. NOTE: Make sure the cable-to-cable connector clip is connected to the front and rear cable before removing the brake control retaining pin, and the cable tension is reloaded slowly.

Disconnect the cable-to-cable connector clip.





4. To reload the tension on the parking brake cable, follow the release procedure in reverse.