Pinpoint Test H: DTC U3003:17

Body Control Module (BCM)

Pinpoint Test H: DTC U3003:17

Normal Operation

- DTC U3003:17 (Battery Voltage: Circuit Voltage Above Threshold)- sets in the Body Control Module (BCM) when the BCM (Body Control Module) detects that battery voltage is more than 16 volts on the voltage supply circuit.

This pinpoint test is intended to diagnose the following:

- Charging system concern

- BCM (Body Control Module)

PINPOINT TEST H : DTC U3003:17

NOTE: DTC U3003:17 may be stored in the module memory due to previous battery charging or vehicle jump starting events.

H1 CHECK FOR DTC B1317, B1676, P0563 (PCM) OR U3003:17 SET IN OTHER MODULES

- Ignition ON.

- Enter the following diagnostic mode on the scan tool: Self-Test.

- Retrieve the continuous memory DTCs from all modules.

Is DTC B1317, B1676, P0563 (PCM) or U3003:17 set in more than one module?

Yes
REFER to Charging System to diagnose an overcharging condition.
No
GO to H2.

H2 CHECK THE BATTERY VOLTAGE

- Turn off all interior/exterior lights and accessories.

- Start and run the engine at approximately 2,000 rpm for 3 minutes while monitoring the battery voltage.

Does the battery voltage rise to 15.5 volts or higher?

Yes
REFER to Charging System to diagnose an overcharging condition.
No
GO to H3.

H3 RECHECK FOR DTC U3003:17

- Turn the engine off.

- Ignition ON.

- Enter the following diagnostic mode on the scan tool: BCM (Body Control Module) Self-Test.

- Clear the continuous memory DTCs.

- Carry out the BCM (Body Control Module) self-test.

Is DTC U3003:17 present?

Yes
INSTALL a new BCM (Body Control Module). REFER to Body Control Module (BCM) . TEST the system for normal operation.
No
The system is operating normally at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.