Wiper Arm: Adjustments

1. Remove the windshield wiper pivot arm and windshield wiper blade from the windshield wiper mounting arm and pivot shaft.
2. Turn the multi-function switch to LO position. allow the windshield wiper motor to move the windshield wiper mounting arm and pivot shaft three or four cycles. and then turn off the multi-function switch. This will place the windshield wiper mounting arm and pivot shaft in park position.







3. Install the arm and blade assemblies on the pivot shafts to Dimension A (RH) or Dimension B (LH).The illustration shows Dimension A and Dimension B.