Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2011 >> Fiesta L4-1.6L >> Repair and Diagnosis >> Instrument Panel, Gauges and Warning Indicators >> Instrument Cluster / Carrier >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Instrument Cluster / Carrier: Service and Repair




Instrument Panel Cluster (IPC)

NOTE: Steering wheel removed for clarity.









Removal

NOTE: If installing a new Instrument Panel Cluster (IPC), all vehicle keys are erased during the parameter reset procedure. Verify at least 2 of the vehicle keys are available prior to carrying out this procedure.

NOTE: If a new non-Intelligent Access (IA) IPC is installed, the IPC and the PCM require a parameter reset to allow the IPC and the PCM to recognize each other. Failure to carry out the parameter reset to the IPC and the PCM may result in a no start condition. Passive Anti-Theft System (PATS) Parameter Reset

1. If installing a new IPC, upload the IPC configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Module Configuration Programmable Module Installation (PMI).

2. Lower the tilt steering column to the lowest setting.

3. Remove the IPC center bolt cover and bolt.





4. Position back the instrument cluster finish panel.

5. Remove the two lower IPC bolts and the IPC.
- Disconnect the electrical connector.





Installation

1. Position the IPC in the instrument panel, connect the electrical connector and install the 2 lower IPC screws.

2. Reposition the instrument cluster finish panel.

3. Install the IPC center bolt cover and bolt.





4. If installing a new IA IPC remove relay R7 from the Central Junction Box (CJB) and jumper pins 3 and 5 together. Download the IPC configuration information from the scan tool into the new IPC. For additional information, refer to PMI in Module Configuration Programmable Module Installation (PMI).
- After configuration, remove the jumper and reinstall relay R7.

5. If installing a new non-IA IPC, carry out the parameter reset procedure. For additional information, refer to Module Configuration [1][2]Initial Inspection and Diagnostic Overview. Passive Anti-Theft System (PATS) Parameter Reset

6. If installing a new non-IA IPC, carry out the key programming procedure. For additional information, refer to Anti-Theft - Passive Anti-Theft System (PATS) Key Programming.

pro multis · About Operation CHARM