Alternator: Service and Repair

Generator - 3.0L









Removal and Installation

1. Remove the A/C compressor. For additional information, refer to Climate Control Service and Repair.

2. Disconnect the battery. For additional information, refer to Battery, Mounting and Cables Battery Disconnect.

3. Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
- To install, tighten to 12 Nm (106 lb-in).

4. Disconnect the generator electrical connector.

5. Remove the 3 bolts and the generator.
- To install, tighten to 47 Nm (35 lb-ft).

6. To install, reverse the removal procedure.