Ignition Coil-On-Plug

Ignition Coil-On-Plug





Removal and Installation

LH side

1. Disconnect the crankcase ventilation tube-to-valve cover fitting quick connect coupling and position aside. For additional information, refer to Fuel System - General Information Quick Connect Coupling.

RH side

2. NOTE: The upper intake manifold must be removed to access the RH ignition coil-on-plugs.

Remove the upper intake manifold. For additional Information, refer to Engine - 3.7L Upper Intake Manifold.

Both sides

3. Disconnect the ignition coil-on-plug electrical connector.

4. NOTE: When removing the ignition coil-on-plug, a slight twisting motion will break the seal and ease removal.

Remove the bolt and the ignition coil-on-plug.

- To install, tighten to 7 Nm (62 lb-in).

5. Inspect the coil seal for rips, nicks or tears. Remove and discard any damaged coil seals.
- To install, slide the new coil seal onto the coil until it is fully seated at the top of the coil.





6. To install, reverse the removal procedure.
- Apply a small amount of dielectric grease to the inside of the ignition coil-on-plug boot before attaching to the spark plug.