Rear Bumper Cover / Fascia: Service and Repair

Bumper Cover - Rear

Removal and Installation

1. Remove the 6 mudflap screws.

2. Remove the 4 rear bumper cover lower valence-to-rear bumper cover pin-type retainers.

3. Remove the 2 rear bumper cover lower valence W-base clips.

4. Remove the luggage compartment rear trim panel.

5. Disconnect the electrical connector from inside the luggage compartment and reposition the rear bumper cover.
- Feed the wiring harness through the rear of the vehicle.

6. Remove the rear bumper cover.
- Pull outward on the sides of the bumper cover to release the bumper cover from the bumper cover brackets.

- Pull rearward to remove the bumper cover.

7. To install, reverse the removal procedure.