Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2011 >> Mustang V8-5.4L SC >> Repair and Diagnosis >> Steering and Suspension >> Steering >> Steering Wheel >> Service and Repair >> Removal and Replacement
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Removal and Replacement




Steering Wheel









Removal and Installation

1. Place the steering wheel in the straight-ahead position and turn the ignition switch to the OFF position.

2. Remove the driver air bag module. For additional information, refer to Supplemental Restraint System Driver Air Bag Module.

3. NOTICE: Do not use a screwdriver or prying device to remove the steering wheel spoke finish panel(s) or damage to the steering wheel may occur. Place fingers near the base of the wheel spoke and gently pull upward to remove the finish panel(s).

NOTE: The steering wheel spoke finish panel(s) can be serviced separately. A new steering wheel does not need to be installed.

NOTE: It is not necessary to remove the steering wheel when installing new steering wheel spoke finish panel(s).

If necessary, remove the steering wheel spoke finish panel(s).

4. Remove and discard the steering wheel bolt.
- To install, tighten the new bolt to 55 Nm (41 lb-ft).

5. Disconnect the steering wheel switches/horn electrical connector from the clockspring.

6. Remove the steering wheel.
- Route the connectors for the clockspring through the steering wheel.

7. Tape the clockspring center rotor to the outer housing to keep it from rotating.





8. To install, reverse the removal procedure.

pro multis · About Operation CHARM