Seat Cushion - Rear

Seat Cushion - Rear









Removal and Installation

1. From under the front of the cushion assembly, push the 2 seat cushion anchor latch release levers toward the driver side, while lifting up to disengage the front of the cushion assembly.





2. Remove the cushion assembly in the following sequence.

1. Push the cushion back as far as possible.

2. Lift up and pull forward at the rear outboard ends of the cushion, disengaging the wires from the retainer hooks.
- Remove the cushion.

3. NOTE: Before installation, make sure the safety belts and buckles are accessible to the occupants.

To Install, reverse the removal procedure.