Headlamp: Service and Repair

Headlamp Assembly

NOTE: RH shown, LH similar.









Removal and Installation

1. Remove the headlamp assembly-to-upper radiator grille reinforcement pin-type retainer.

2. Remove the 3 headlamp assembly bolts.
- To install, tighten to 5 Nm (44 lb-in).

3. Gently lift up on the headlamp assembly to disconnect assembly from the lower clip.

4. Disconnect the headlamp assembly electrical connectors and disengage the wiring assembly clips from the headlamp assembly.

5. NOTE: The headlamp assembly has a lip that must fit under the front bumper assembly to insure proper fit.

Remove the headlamp assembly.





6. To install, reverse the removal procedure.
- If necessary, adjust the headlamps. For additional information, refer to Headlamp Adjustment Adjustments.