Tire Pressure Sensor Location (USA)

Tire Pressure Sensor Location

Special Tools Required

- TPMS Trigger Tool ATEQ VT55
*Available through the Honda Tool and Equipment Program 888-424-6857

NOTE:

- Make sure the TPMS tool has the latest software. Check the official Honda service website for more service information about the TPMS tool.
- The TPMS tool is necessary to do this procedure.
- Let the vehicle sit for at least 5 minutes to allow the pressure sensors to switch to sleep mode.
- This procedure locates where the tire pressure sensors 1, 2, 3, 4 are mounted, when activated by the TPMS tool.
- Position the vehicle at least 10 ft (3 m) away from other vehicles that have tire pressure sensors.

1. With the ignition switch in LOCK (0), connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.






2. Turn the ignition switch to ON (II).

3. Make sure the HDS communicates with the vehicle and the TPMS control unit. If it does not, go to DLC circuit troubleshooting Testing and Inspection.

4. Using the HDS, bring up the TPMS DATA LIST, scroll down to the bottom, and locate the four tire sensors ID numbers. These are the sensor ID numbers assigned to each tire location.

5. Follow the HDS screen prompts to turn on the TPMS tool.

6. Activate the TPMS sensor using the ATEQ VT55 tool.





7. The ATEQ VT55 will display the sensor data including the ID number.

8. Locate the ID number on the TPMS data list, and match it to the tire sensor number. Note the sensor location.

9. Turn the ignition switch to LOCK (0).